EF HB-BI 291-T Gebrauchsanweisung Seite 34

• Error codes:
Error code: Description:
C
The cooking zone can be
configured if a static "C" is
shown.
C/-
The cooking zone will be
configured if a blinking "C"
is shown. After a successful
configuration the relevant
display shows "-".
When the "-" is not displayed
please check the possible
causes of the E/5.
E
A blinking "E" on each cooking
zone indicates, that all configs
will be deleted.
E/2
Temperature limits are
excessed.
E/3 Unsuitable pot.
E/4
Unconfigured induction
modul.
E/5
No communication between UI
and induction modul.
E/6
Main power disturbance.
E/8 Fan failure.
E/9
Defect T sensor on inductor.
E/A
Hardware defect of induction
modul.
E/C
Configuration failure.
E/H Fixed sensor value.
Possible causes:
It's not an error, the user is in
the service menu.
The user is in the service menu,
it's not an error.
The user is in the service menu,
it's not an error.
Electronik temperature to high.
Pot creates on the modul an
improper operating point
which can destroy devices,
e.g IGBT' .
Induction modul is not
configured.
No power supply of induction
modul.
1. Failure in main power
frequency detection.
2. Over voltage.
Fan or control electronic is
defect.
Sensor signal out of valid
range; sensor or electronic is
defect.
Defect hardware device
detected by the self check of
the modul.
2 cooking zones are dedicated
to the same element of the UI.
-
- 34 -
Error recovery:
A suitably pan must be placed on the
relevant cooking zone.
Wait for the sysmbol "-" or abort the
configuration activities by pressing the
selectkey and the "C" does not blink
anymore.
Manual configuration.
System must cool down.
1. The error is automaticly cancelled
after 8s and the cooking zone can
be used again. In case of further
upcoming errors the pot have to be
changed.
1. Delete the hob configuration and
activate the manual configuration.
2. Start the UI service menu to
configure the induction modul.
Contact the technical Service.
Contact the technical Service.
Contact the technical Service.
Contact the technical Service.
Contact the technical Service.
1. Erase the actual configuration
manual configuration with service
menu.
System must cool down.