Maintaining And Cleaning The Consumers; Troubleshooting; Maintenance And Cleaning - Wetekom 82 99 06 Bedienungsanleitung

The stored allocation between the foot switch and the socket-
outlet is deleted.

Maintaining and Cleaning the Consumers

If you want to clean or maintain the consumers, such as changing
the illuminant of a lamp etc., first unplug it from the socket-outlet. It
is not sufficient to switch off the socket-outlet with the foot switch
alone!
Due to the single-pole cut-off and the commonly used transmission
frequency, there is risk of an electric shock if the consumer is switch
on unintentionally.

Troubleshooting

 Poor reception indicates that the battery of the foot switch should
be replaced. Observe the polarity when changing the battery.
 If the consumer load, for example a reading lamp cannot be
switched on, check if the device is plugged in or if the illuminant
is defective.
 Keep in mind that other wireless applications active on the same
frequency band may cause interference. If possible, switch off
those applications while using the foot switch.

Maintenance and Cleaning

 If you do not use the foot switch for a long period of time, remove
the battery.
 Unplug the socket-outlet before cleaning it.
 Do not clean the foot switch and the socket-outlet with abrasives
or aggressive chemicals in order no to damage the surfaces.
Only clean the units with a lightly moistened cloth.
 Make sure that no liquids can enter the interior of the foot switch
and the socket-outlet.
Operating
16