Using The Emergency Light; Changing The Fuse In The 12 V Adaptor - Westfalia 41 61 15 Bedienungsanleitung

Using the Emergency Light

1. To use the light, press the switch (5) in direction
LIGHT for bright light
FLASH for flashing light
OFF in order to switch off the light.
2. Open the emergency lens in order to use the unit as a work light.
Changing the Illuminant
Make sure the illuminant has cooled down completely and the compressor is
switched off before changing the illuminant.
1. To change the illuminant, first open the emergency light.
2. Insert a screwdriver into the provided sidewise hole and lever out the
transparent lid.
3. Turn the illuminant lightly to the left or to the right and pull the illuminant
out of the bulb socket. The illuminant has a bayonet coupling.
4. Insert a new illuminant of the type 12V/10W, bulb socket BA 15 into the
socket. To lock the illuminant, lightly turn it to the left or to the right.
5. Place the transparent lid with the convex side on the lamp holder. Press
the edge down until the lid locks audible.

Changing the fuse in the 12 V Adaptor

The power plug of the 12 V adaptors contains a quick micro fuse. In the case
of a failure replace it with one of the same type and dimensions.
Start-Up and Operation
10