Technical Characteristics; Troubleshooting - Ceanothe DECOWATT 400x1200 Einbau- Und Nutzungsanweisung - Garantie

V. Technical characteristics
Main voltage
Maximum intensity per heater
Class
Protection index
Conformity
SEE THE ENTIRE DECOWATT RANGE AT WWW.CEANOTHE.COM
Power – heating surface
500 W –>10 m²
750 W –> 15 m²
750 W –>15 m²
1 200 W –> 20 m²
VI. Troubleshooting
NATURE OF THE PROBLEM IDENTIFIED
The device does not produce heat
The device does not stop
producing heat
The device does not follow
programmed orders
230V (50 Hz)
5 A
II
IP 44
CEI60335-1, CEI60335-2-30, CEI60335-2-43 et
EN50014-1, EN50014-2, EN61000-3-2, EN61000-3-3
Width Length
400 mm 1 200 mm
600 mm 1 200 mm
400 mm 1 800 mm
600 mm 1 800 mm
CHECK
1. Make sure that the
indicator light is on
2. The indicator light is on, the
heating indicator is off and
the red indicator light is off
3. The indicator light is still off
Make sure that the temperature
set via the thermostat has
not been modified
Make sure that the device is not
located close to a cold room
Make sure that the
receiver is operating
Ensure the proper use of the
programming feature
36
Weight Bar spots
10,6 kg
15,6 kg
15,8 kg
23 kg
ACTION
Place the interruptor located on the
side of the device on position I
Check the temperature defined
via the thermostat
The room temperature is sufficient and
there is no need for further heating
Make sure that the circuit
breakers are engaged
Set a new temperature
Close the door, heat up the room
Turn the interruptor to position I
Check the batteries
Check the proper operation
of the program
2
2
6
6