Werbung
Verfügbare Sprachen
Verfügbare Sprachen
For connecting the camera to the reverse light it is recommended to use the wire connector.
Installation and Connection of the Receiver:
Optionally it is possible to get electric power for the monitor via the vehicle's fuse box. Doing so connect the red
cable to its 12V+/ 24V DC ACC-terminal. The black grounding cable must be connected to a bare metal site of
the car's body.
Disconnect the negative cable of the car battery during this installation process.
P2008 © Firma WJG, Braunschweig. Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung
Remove the paper from the monitor holder and attach
it to the monitor by inserting it into the notch on the
backside of the monitor.
Attach the other side of the holder with its vacuum
cup to the desired spot of the inner front shield. Make
sure that the monitor is attached firmly.
Plug the power supply cable to the cigarette lighter of
the vehicle and connect the other side to the
connector of the monitor
Adjust the correct receiving channel with the switch at
the side of the monitor.
Set the ignition lock to ON then the monitor can be
switched on.
A DVD-player can be connected to the monitor
optionally using the audio-/video-cinch connectors.
968-407
Werbung
