Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUBLE SHOOTING
NO SOUND
Ensure the AC adaptor is fully inserted into the AC outlet and the power connection input on
-
the transmitter.
Ensure the speaker is switch ON.
-
Speaker's battery capacity is too low, replace with new batteries or connect the AC adaptors to
-
the speakers.
Ensure the TV or audio component is ON.
-
The connected audio / video equipment is not playing. Start playing the equipment
-
The volume of speaker is too low, adjust the volume to an appropriate level.
-
DISTORTED
Press the "SCAN" button on the speakers until matching the frequency of the transmitter.
-
Change the position of the channel selector on the transmitter. You must then press the SCAN
-
button on the speaker.
Battery capacity is too low. Replace with the new battery.
-
Ensure the volume level of speakers is adjusted properly.
-
The speaker is too far from transmitter, move closer.
-
The input level of the audio signal is too low. Turn up the volume of the audio source
-
equipment.
SPECIFICATIONS
Transmission Mode
Carrier Frequency
Number of channels
Operation Voltage
Frequency Response
Distortion
S/N Ratio
Channel Separation
Operation Distance
Warranty
Warning : Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
0889
Made in PRC
UHF stereo
863 MHz
3 Adjustable on transmitter rear side
Transmitter, DC 12V 200mA
Speaker, 6 X 'AA' size Alkaline batteries
or DC 12V 450mA adaptor
20Hz - 13KHz
1.5%
50dB
30dB
Up to 100M (Open Area)
2 Years
- 9 -
Werbung
Inhaltsverzeichnis
