Operation - CGV SSP 200 Bedienungsanleitung

INSTALLATION
TRANSMITTER
1. Insert the antenna tube into the antenna wire.
2. Connect the supplied AC power adaptor to an electrical wall outlet.
3. Plug the AC power adaptor in the DC jack located on the rear of the transmitter.
4. The rear of the transmitter has one audio cord that can be connected to audio output jack of TV,
Monitor, VCR, Radio recorder, CD/MP3/VCD/DVD players or to headphone/earphone jack
with the connector provided.
5. Plug the adaptor in the AC source and connect the audio plug to the audio source. As soon as the
transmitter is receiving the audio signal, it will automatically switch on and the red LED will
illuminate.
SPEAKER RECEIVER
1. Insert 6 pieces 'AA' size ALKALINE battery into the battery compartment with correct polarity
at the rear of the speaker or connect the 12V power adaptor to the DC input jack on the rear of
each speaker, then plug it to the wall AC outlet.
2. Switch on the speaker by turning up the VOLUME ON/OFF knob towards ON direction. The
POWER/STEREO LED will light up. Switch off the speaker by turning down the VOLUME
ON/OFF knob towards OFF direction until a "click" sound is heard.

OPERATION

1. Turn on the audio source (TV or audio component) to which the
transmitter is connected with. The LED on transmitter will light
up.
2. Select the channel 1 or 2 or 3 of the transmitter for best
performance in your location.
3. Select the MONO/ST selector on the transmitter to ST for the best stereo reception.
a. In case the audio device only provides Mono audio signal, select the MONO/ST selector
to MONO for the best mono reception.
4. Turn on the ON/OFF VOLUME knob on the speaker and adjust the volume to the desired
listening level.
5. Push the "SCAN" auto-tuning button to get the best tuning reception in the speakers. When the
button is pressed, frequency tuning starts automatically and it stops when a signal is detected.
The POWER/STEREO LED will change from red to orange.
- 7 -