Herunterladen Inhalt Inhalt Diese Seite drucken

Initial Operation; Cleaning And Maintenance - Conrad PSM 2010 Kurzanleitung

Labornetzgeräte
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Initial operation

Connect the provided mains cable to the mains connector at the back of the device and connect
the Schuko plug to an earthed mains socket.
Swich on the device with the power switch (POWER I/0).
After a short initialisation phase the device is ready for operation.
Connect the corresponding measuring lines to the CD-connectors. The red connector corre-
sponds with the positive pole, the black one with the negative pole.
The ground potential connector is connected directly to the protective earthing
of the mains plug.
Turn off the device after completing operation.

Cleaning and maintenance

Always observe the following safety instructions before cleaning the device:
Live components may be exposed if covers are opened or parts are removed
(unless this can be done without tools).
Prior to cleaning or repairing the device, all lines have to be detached and the
device has to be turned off.
Always replace defective micro-fuses by new ones of the indicated type and
rated amperage. Using repaired fuses or bypassing of the fuse carrier is inad-
missible due to safety reasons.
Do not use scouring, chemical or aggressive cleaning agents such as benzine, alcohol or the like.
These might attack the surface of the device. The fumes are furthermore a health hazard and are
explosive. Moreover, you should not use sharp-edged tools, screwdrivers or metal brushes or
similar for cleaning.
For cleaning the device or the display and the measuring lines, use a clean, fuzz-free, antistatic
slightly damp cloth.
Should questions occur concerning the handling of the device, feel free to con-
tact our technical support under the following phone number:
Conrad Electronic SE, Klaus-Conrad-Str. 2, 92530 Wernberg,
Phone 0180 / 531 211 8
Disposal
Electronic products are a raw material and do not belong in household waste. When
the device has reached the end of its service life, dispose of it in accordance with the
current statutory regulations at the communal collection points.
Disposal in the domestic waste is not permitted.
You thus fulfil the legal requirements and make your contribution to the protection of the envi-
ronment!
These operating instructions are published by Conrad Electronic SE,
Klaus-Conrad-Straße 1, D-92240 Hirschau/Germany.
The operating instructions reflect the current technical specifications at time of
print. We reserve the right to change the technical or physical specifications.
© Copyright 2007 by Conrad Electronic SE. Printed in Germany.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis