Product Description And Specifications; Technical Data - Bosch PTA 2000 Originalbetriebsanleitung

OBJ_BUCH-1563-003.book Page 12 Monday, December 5, 2016 4:20 PM
12 | English
 Ensure that long and heavy workpieces do not affect
the equilibrium of the saw stand. Long and heavy work-
pieces must be supported at the free end (e. g., with the
Bosch PTA 1000 roller stand).
 Keep your fingers clear of the hinge points while set-
ting up or folding together the saw stand. Danger of fin-
gers being crushed or contused.
Symbols
The following symbols can be important for the operation of
your saw stand. Please memorise the symbols and their
meanings. The correct interpretation of the symbols helps
you operate the saw stand better and more secure.
Symbol Meaning
The maximum carrying capacity (power
tool + workpiece) of the saw stand is
125 kg.
Mount the power tool only as shown in the
corresponding figure.
(see figures B1–B2)
Observe the operating position. When
working, always position yourself on the
side of the wheels. (see figure C)
 Do not overload the saw stand and
do not use it as a ladder or scaffold-
ing. Overloading or standing on the
saw stand can lead to the upward shift-
ing of the centre of gravity of the stand
and its tipping over.
Indicates the individual steps for setting up the saw stand.
1. Pull the release button
2. Step on the transport handle and pull the handle upward
3. Firmly tighten the locking knob
Indicates the individual steps for folding the saw stand to-
gether.
1. Loosen the locking knob
2. Pull the handle upward a little
3. Pull the release button
4. Slowly lower the saw stand by the handle
1 609 92A 1M3 | (5.12.16)
Product Description and
Specifications
Intended Use
The saw stand is intended to accommodate the following sta-
tionary saws from Bosch (as of 2012.02):
– PPS 7S
– PTS 10
Together with the power tool, the saw stand is intended for
the cutting to length of boards and profiles.
Product Features
The numbering of the product features refers to the illustra-
tion of the saw stand on the graphics pages.
1 Handle
2 Lock/release button
3 Cross brace
4 Retaining adapter
5 Locking knob
6 Resting bar
7 Transport wheels
8 Transport handle
9 Fastening kit, power tool
10 Limit bolt of the resting bar
Accessories shown or described are not part of the standard deliv-
ery scope of the product. A complete overview of accessories can
be found in our accessories program.

Technical Data

Saw stand
Article number
Height of saw stand mm
Max. carrying capacity
(power tool + workpiece)
Weight according to EPTA-
Procedure 01:2014
Assembly
Delivery Scope
Before assembling the saw stand, check if all parts listed be-
low are provided:
– Saw stand PTA 2000
– Fastening kit 9 consisting of:
Hexagon bolt M8 x 45 (3 pce.),
Hexagon bolt M8 x 55 (1 pce./PPS 7 S),
Hexagon bolt M8 x 35 (1 pce./PTS 10),
Washers (4 pce.),
Self-locking nuts with serrated bearing, M8 (4 pce.)
Additionally required tools (not in delivery scope):
– Open-end spanner (13 mm) (2 pce.)
– Allen key (5 mm)
3 603 M03 3..
3 603 L03 2..
PTA 2000
3 603 M05 300
595
kg 125
kg 13.0
Bosch Power Tools