h.koenig BW1880 Bedienungsanleitung Seite 8

1. Top cover
2. CO2 cartridge sheath
3. Tap handle
4. Tap
5. Keg lifter
6. LED display
7. Digital control button
INSTALLATION & OPERATION
A. INSTALLATION
1. Take out the beer cooler from its package. Place the beer cooler
on a steady and horizontal surface, and make sure the beer cooler is
at least 5inches/10 cm away from other appliances or wall on each
side so as to allow correct ventilation on the appliances, get better
performance.
Figure 6
2. Install the tap handle connect the tap, make sure both end fit
together perfectly. (Show as Figure 6)
3. Set the water drip tray into the notch provided. (Show as figure 7)
4. Plug the beer cooler.
Note: Do not connect or disconnect the electric plug when your
8. Drain switch
9. Drip tray
10. CO2 pressure relief valve/ knob
11. Door lock button
12. Rear cover
13. Power cord & plug
14. AC power switch
Handle
Faucet Drip tray
Figure 7