Klauke HK 4 Bedienungsanleitung Seite 22

Instruction manual HK 4
___________________________________________________________________________
4.3. Description of the crimping processes
The crimping process is defined by the closing motion of the dies. During that process the
connecting material is positioned in the stationary half of the die whereas the moving part
of the die is approaching the compression point.
The crimping process is terminated when the dies contact each other. This is indicated by
an acoustic signal, a „click", which signals that the high pressure valve has opened and that
the maximum operating pressure has been reached.
After pressing the reset key the dies return to the starting position. Afterwards a second
crimping cycle can be initiated or the crimping process can be terminated by opening the
latch.
Instruction manual HK 4
___________________________________________________________________________
4.3. Description of the crimping processes
The crimping process is defined by the closing motion of the dies. During that process the
connecting material is positioned in the stationary half of the die whereas the moving part
of the die is approaching the compression point.
The crimping process is terminated when the dies contact each other. This is indicated by
an acoustic signal, a „click", which signals that the high pressure valve has opened and that
the maximum operating pressure has been reached.
After pressing the reset key the dies return to the starting position. Afterwards a second
crimping cycle can be initiated or the crimping process can be terminated by opening the
latch.
page 22
page 22