Installation - Fakir LE 46 Gebrauchsanleitung

le46.qxd 12.01.04 12:31

Installation

The hold-away carrying handle [5] and the four castors [14] make it easy to move the
dehumidifier to the room that is to be dehumidified. Unimpeded air circulation is neces-
sary for perfect operation, i.e. there must be at least 50 cm of free space all around the
appliance.
Two ways to drain off the condensed water:
Draining into the tank
With this standard function the condensed water is automatically collected in the tank [9].
A float switch [10] in the tank turns on the "Full Tank" indicator [1] as soon as the water
reaches maximum level in the tank.
Remove the water tank from the front of the appliance and empty. Ensure that the tank is
properly returned. The "Full Tank" indicator is turned off and the dehumidifier is ready to
resume operation.
Drain off to the outside
With this special function the condensed water is conducted by way of a hose directly into
a drain in the floor. This can be of immense advantage when dehumidifying cellars since
it is no longer necessary to regularly empty the full water tank, thereby enabling conti-
nuous operation.
1. Remove the condensed water tank [9].
2. Remove the small prepunched cover [13] at the back of the appliance.
3. Push a draining hose (Ø 14mm) of suitable length through the resulting opening and
over the drain pipe.
4. Conduct the draining hose to the drain in the floor and ensure that the condensed
water can flow off unimpeded.
Electrical connection
Complete the following checks before the appliance is connected to the mains:
1. The mains voltage must match the voltage specified on the type plate.
2. The mains socket must be correctly earthed and protected by an automatic fuse (at
least 16 A).
3. The power supply plug must be suitable for the given mains socket; the plug must be
exchanged by a skilled authorized person if this is not the case.
The manufacturer cannot be held liable if these accident prevention rules are not obser-
ved.
Seite 17
Function and use
17