Miscellaneous - Medisana MC 826 Gebrauchsanweisung

3 Operating / 4 Miscellaneous
GB
3.2 •
Operation
•
•
•
•
•

4 Miscellaneous

4.1 •
Cleaning
and •
main-
tenance
•
18
You can enhance the Shiatsu massage at any time with a vibration
massage for your thighs by pressing the vibration massage button
u
.
The vibration massage in the upper thigh area can also be operated
separately by pressing vibration massage button
tor LED "1" next to the button lights up and both vibration massage
motors are switched on. They begin with a gentle massage. Press
button again and the vibration level increases (medium intensity
massage LED "2"). Press button a third time and the maximum vibra-
tion level (highest intensity massage, LED "3") is switched on. After
button is pressed a fourth time, the vibration massage is switched off
and LED "3" next to the button goes out.
To switch on the air massage for the lumbar area press button
The LED "1" next to the button lights up (1 = low intensity). A second
press on the button
sity). A third press on the button
high intensity). After button is pressed a fourth time, the air massage
is switched off.
The heat function can be activated at any time with the Shiatsu or
tapping massage, during which the vibration massage can also be
activated. Press the heat button
LED lights up. The heat is radiated through the massage heads
i
Press the button
goes out.
To switch off the device: Press the On/Off button
er LED begins to flash and the massage heads travel back
down to the "Park" position. When this position is reached,
the LED extinguishes. If you press the On/Off button
when one of the massage functions is switched on, the vibration
motors just stop immediately. First the massage heads travel down-
wards to the "Park" position. The power LED flashes meanwhile and
then extinguishes.
After each use, switch the device off using the On/Off switch
and remove the plug from the mains socket.
Before cleaning the device, make sure that it is turned off and the
mains plug is removed from the socket. Allow the unit to cool down.
Only clean the Shiatsu massage seat cover with a soft cloth slightly
dampened with a mild detergent (e.g. soap suds). Under no circum-
stances should you use aggressive detergents, strong brushes, sol-
vents or alcohol.
When cleaning, never immerse the unit in water and make sure that
no water gets into the unit.
z
increases the intensity (2 = medium inten-
z
increases the intensity again (3 =
i
to activate the function; the
again to de-activate the heat function; the LED
u
. Level indica-
z
.
2
.
5
. The pow-
5
5