Medisana MC 826 Gebrauchsanweisung Seite 25

Use the buttons on control pad to operate the massage seat cover:
3.2
Operation • Switch on the device by pressing On/Off button
illuminates.
• The buttons
adjust the position and the rotation direction of the both massage
heads. The LEDs next to the buttons
tating direction is active.
• The buttons
massage for the back area. With the button
spot massage (only with tapping massage).
• When the "Upper Back" massage button
next to the button illuminates and the Shiatsu massage heads
move from the "Park" position at the base of the backrest, up to the
shoulder area, massaging the back in a circular motion whilst doing
so. Once the uppermost position has been reached, the direction of
rotation of the massaging heads is reversed. The heads then travel
down to the centre of the back. Once the heads reach this point, the
direction of rotation is reversed again and then travel up the back
again. If you press button
switched off and the massage heads remain stationary in their cur-
rent position.
• If you press the "Lower Back" massage button
the button illuminates. The Shiatsu massage heads
down the lower half of the back in a circular motion. The reversal of
the direction of rotation takes place when the respective end posi-
tions are reached. Pressing button
off this function and the massage heads remain stationary in their
current position.
• If you press the "Full Back" massage button
dure is similar to pressing buttons
entire back.
• To activate a tapping massage for the selected back area, press
the button
the tapping massage mode (mode 1 = constant massage, mode 2
= massage with pauses, mode 3 = alternating mode 1 and mode 2
with change of moving direction). If mode 3 is active and you press
the button
• The button
After switching on the tapping massage the LED "1" next to the but-
ton lights up (1 = low intensity). A press on the button
the intensity (2 = medium intensity). A second press on the button
r
pressed a third time, the tapping massage intensity is set back to
intensity 1.
• During the tapping massage, press button
sage.
6 7 8
, ,
0 q w
, ,
e
. By repeatedly pressing this button, you can change
e
again, the tapping massage will be switched off.
r
(level) controls the intensity of the tapping massage.
increases the intensity again (3 = high intensity). After button is
9
and control the neck massage. You may
8
e r t
, , and allow a Shiatsu- or tapping
0
during the massage, this function is
w
during the massage, switches
0
and
3 Operating
5
. The power LED
9
and indicate, which ro-
t
you may activate a
0
is pressed, the LED
w
, the LED next to
2
travel up and
q
the function proce-
w
, except that it is for the
r
increases
t
to activate spot mas-
GB
2
17