Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
H
s
-
ardWare
et
(c
lose all ProGrams before coNtINuING
USB driver install:
• Connect your PCSU200 unit to a free USB port
• Follow the on screen driver installation procedure.
• If Windows asks for Windows Update, select "not at this time"
• Install the driver from a specific location, then browse your drive and select the folder "PCSU200Driver".
(press "next")
• If Windows indicate "has not passed Windows logo testing..." select "Continue Anyway".
• After finishing, you can check the driver installation in the Device Manager list.
• It is possible that the PC asks to "restart" for proper installation
Starting the software :
Locate the Pc-Lab200 software shortcuts (programs.. Pc-Lab200 ...)
Click the
icon to start the main program. "loading, please wait" should appear. Then the channel indicator
LEDs must go ON. (*)
The main program automatically launches the Oscilloscope and generator screen, which is shown on the next
pages. Should you receive an error (ex. If no unit is detected), disconnect and reconnect the USB cable and
try again or, if you want to access the demo mode (no unit is needed) :
- Click the
Options
menu, and select
'Hardware Setup'
Note:
• At first time power-up, the oscilloscope will calibrate itself automatically.
• The actual screens can differ from the one shown in this manual.
6
uP
)
> demo mode
t
f
G
He
uNctIoN
eNerator
What ? :
Most common wave-forms are
accessible at the touch of a
button. A library with special
functions is provided, as well
as a Wave Editor, to create
virtually any kind of waveform.
How ? :
• Click on the desired waveform (1).
• Select the desired frequency range (2).
• Set the exact frequency by sliding (3) or click the frequency readout (4) and enter a value.
• Adjust the amplitude (5)
• (6) shows a simulated preview of the output waveform
The 'More Functions'- button :
The 'More Functions'-button gives access to special purpose waveforms such
as arbitrary waveforms, and frequency sweeps. It also gives access to the
waveform library.
Note: The Probe test button (7) makes the generator output a signal, suitable
for your scope probe calibration at X10 setting.
m
:
odule
6
7
4
3
2
1
5
7
Werbung
Inhaltsverzeichnis
