Rear Panel; Getting Started; Important Notes; Rack Mounting A Single Antenna Combiner - AKG SPC 4 Bedienungsanleitung

AKG SPC 4

2.4.2 Rear Panel

Fig. 2: Inputs and outputs on the SPC 4 rear panel.
Refer to fig. 2.
4 ANTENNA OUT: BNC output connector for an SRA 2 W or RA 4000 W
transmitting antenna. You may also connect this output to a transmitter
input on another SPC 4.
5 INPUT 1-4: BNC inputs for connecting one to four SST 4 stereo
transmitters.
6 DC ONLY 12 V/1.4 A: DC input for an AC adapter with a 12 VDC/≥1.4 A
output (not included) for powering the SPC 4.
7 DC ONLY 12 V/2 A: DC input for connecting the optional PSU 4000
central power supply for powering the SST 4 transmitters connected to the
SPC 4.

3 Getting Started

3.1 Important Notes

1. Make all antenna cable connections before connecting the unit to
power.
2. Do not connect to the SPC 4 to any antenna other than the SRA 2 W
or RA 4000 W from AKG. Using other antenna types may cause
malfunctioning of the SPC 4.
3. Position the unit such that the front panel ventilation grill cannot
be covered. Obstructing the air intake may cause the unit to
overheat.

3.2. Rack Mounting a Single Antenna Combiner

Refer to fig. 6.
1. Unscrew the four rubber feet (1) from the antenna combiner bottom panel.
2. Unscrew the two fixing screws (2) from each side panel.
3. Use the fixing screws (2) to screw the short bracket (3) to one side panel
and the long bracket (4) to the other side panel. The brackets are
contained in the supplied rack mounting kit.
4. Install the antenna combiner in your rack.

3.3 Rack Mounting Two Antenna Combiners Side by Side

Refer to fig. 7.
1. Unscrew the four rubber feet (1) from each antenna combiner's bottom
panel and remove the screws (5) from the rubber feet (1).
2. Unscrew the two fixing screws (2) from the right-hand side panel of one
antenna combiner and from the left-hand side panel of the other antenna
combiner.
3. Remove the plastic covers (3) from the side panels with the fixing screws
(2) still on.
4. Insert one connecting strip (4) into each free slot in the side panel of the
first antenna combiner, making sure to align the hole in each connecting
14/20