Troubleshooting; Technical Specifications - Scout PG DT Bedienungsanleitung

5. Troubleshooting

If the wheelchair will not function while the batteries are fully charged, check the
following points before consulting your dealer:

Switch the controller off and then switch it on again. Check to see if the malfunction
has been solved.

Check if the free wheel switch was switched to Drive.

Check if the joystick was in the 0 position when the controller was switched on. In
other words, the joystick must not be moved when the controller is being switched ion
or off.
Malfunctions list
An extended malfunction list can be found in the appendix of the service manual (for
qualified specialists only). The service manual can be found on

6. Technical specifications

Supply Voltage:
Operating Voltage:
Peak Voltage:
Reverse Battery Voltage:
PWM Frequency:
Brake Voltage:
Brake Current:
Charger Connector:
Batt. Charging Current:
Actuator Current:
Maximum Drive Current:
Moisture Resistance:
Operating Temperature:
Storage Temperature:
EMC tested on sample wheelchair:
Susceptibility:
Emissions:
ESD:
Troubleshooting / Technical specifications
24Vdc
16Vdc to 35Vdc
35Vdc
40Vdc
20kHz ± 0.5%
12Vdc or 24Vdc
100mA min.
1A max.
Use only Neutrik NC3MX
12Arms max.
12A max.
VR2 50 50A
VR2 60 60A
VR2 70 70A
VR2 90 90A
IPx4
-25°C to +50°C
-40°C to +65°C
Tested at 30V/m to EN12184 (1999) and ANSI/
RESNA requirements
To EN55022 Class B
IEC801 part 2
www.scoutmobility.nl
21