Selecting The Desired Adjustment Option; Lights - Scout PG DT Bedienungsanleitung

Lights

3.1

Selecting the desired adjustment option

1. Switch on the controller
2. Press on the 'mode' button (E in figure 1.2) to select the 'adjustment options' mode.
The controller will now be in the 'adjustment options' mode. It is also possible to
follow the status.
The joystick is used to select and operate the electronic adjustment options.
3. Move the joystick to the left or the right to select the desired adjustment option. The
selected adjustment option will be visible on the display screen.
4. Moving the joystick forwards and/or backwards will activate the selected electronic
adjustment option (see table 3.1). Move the joystick forwards or backwards until the
desired adjustment option has been attained.
Tilt adjustment
High/low
adjustments
Backrest
adjustments
Legrest
adjustments
Table 3.1 Electrical adjustments
5. To return to the 'drive' mode: Press on the 'mode' button to select the 'drive' mode.
Note: If you move the chair while adjusting the high/low option, the speed will be
reduced.
4. Lights
Not every wheelchair has been equipped with lights. You can activate the following
functions only by using VR2 Lights and/or VR2 Seat&Lights:

Lights (I in figure 1.2)

Hazard Lights (J in figure 1.2)

Direction indicators (K1 & K2 in figure 1.2)
20
Move joystick backwards
The entire chair will tilt
backwards
The entire chair will be raised
The backrest will tilt
backwards
The legrest angle will
increase, the footplate will be
raised
Move joystick forwards
The entire chair will tilt
forwards
The entire chair will be
lowered
The backrest will tilt
forwards
The legrest angle will
decrease, the footplate will
be lowered