Adam Hall AHPCS10 Bedienungsanleitung Seite 7

QUICK SETUP GUIDE
To set up your AH Power Distribution and Conditioning unit just follow the steps below:
1. Remove all packaging materials and mount the unit in your 19" rack (please keep the original packaging
for return shipment if the unit should require servicing). We recommend to install the AHPCL10 and AHP-
CL10PRO on top of the other rack equipment for most effective rack lighting.
2. Connect your AH Power Distribution and Conditioning unit to a standard grounded mains power outlet. On
the AHPCL10PRO the front panel voltmeter and ammeter displays will indicate the incoming voltage and
the current draw of the equipment connected to the unit.
3. Make sure all equipment to be powered from your AHPCS10, AHPCL10 or AHPCL10PRO is switched off
before connecting the power cords to the switched outlets on the rear panel of your AH Power Distribution
and Conditioning unit. The included IEC cords can be used to connect equipment with IEC mains power
inputs.
4. Flip the front panel "Outlets" switch to activate the rear panel outlets. The switch includes a red status
indicator that lights up when the outlets are active.
5. Switch on the connected equipment separately and in succession. In case the total current draw exceeds
10 amps the AH Power Distribution and Conditioning unit's circuit breaker will trip. Disconnect one or more
pieces of your rack equipment and push in the front panel circuit breaker to reset.
6. The unswitched convenience outlet on the front panel is independent of the "Outlets" switch providing
power whenever your AHPCS10, AHPCL10 or AHPCL10PRO's mains cord is plugged into an appropriate AC
outlet. Please note that the circuit breaker also affects the convenience outlet!
7. To illuminate your rack equipment the AHPCL10 and AHPCL10PRO feature twin 5-LED rack lights that turn
on automatically when they are pulled out. Slide the light barrels back in to switch them off again.
8. To illuminate the back of your rack connect the included gooseneck LED lamp to the dedicated rear panel
USB socket.
7