Adam Hall PRO PORT 4 PP Kurzanleitung

PRO PORT 4 PP
POWER DISTRIBUTION STRIP
WITH 1 X POWER TWIST INPUT + 5 X POWER TWIST OUTPUTS
SAFETY INFORMATION
1. Please read these instructions carefully.
2. Keep all information and instructions in a safe place.
3. Follow the instructions.
4. Observe all safety warnings. Never remove safety warnings or other information from the
equipment.
5. Use the equipment only in the intended manner and for the intended purpose.
6. Use only sufficiently stable and compatible stands and/or mounts (for fixed installations).
Make certain that wall mounts are properly installed and secured. Make certain that the
equipment is installed securely and cannot fall down.
7. During installation, observe the applicable safety regulations for your country.
8. Never install and operate the equipment near radiators, heat registers, ovens or other sourc-
es of heat. Make certain that the equipment is always installed so that is cooled sufficiently
and cannot overheat.
9. Never place sources of ignition, e.g., burning candles, on the equipment.
10. Ventilation slits must not be blocked.
11. Do not use this equipment in the immediate vicinity of water (does not apply to special out-
door equipment - in this case, observe the special instructions noted below. Do not expose
this equipment to flammable materials, fluids or gases.
12. Make certain that dripping or splashed water cannot enter the equipment. Do not place con-
tainers filled with liquids, such as vases or drinking vessels, on the equipment.
13. Make certain that objects cannot fall into the device.
14. Use this equipment only with the accessories recommended and intended by the manufac-
turer.
15. Do not open or modify this equipment.
16. After connecting the equipment, check all cables in order to prevent damage or accidents, e.g.,
due to tripping hazards.
17. During transport, make certain that the equipment cannot fall down and possibly cause prop-
erty damage and personal injuries.
18. If your equipment is no longer functioning properly, if fluids or objects have gotten inside the
equipment or if it has been damaged in another way, switch it off immediately and unplug
it from the mains outlet (if it is a powered device). This equipment may only be repaired by
authorized, qualified personnel.
19. Clean the equipment using a dry cloth.
20. Comply with all applicable disposal laws in your country. During disposal of packaging, please
separate plastic and paper/cardboard.
21. Plastic bags must be kept out of reach of children.
FOR EQUIPMENT THAT CONNECTS TO THE POWER MAINS:
22. If the equipment has been exposed to strong fluctuations in temperature (for example, after
transport), do not switch it on immediately. Moisture and condensation could damage the
equipment. Do not switch on the equipment until it has reached room temperature.
23. Before connecting the equipment to the power outlet, first verify that the mains voltage and
frequency match the values specified on the equipment. If the equipment has a voltage selec-
tion switch, connect the equipment to the power outlet only if the equipment values and the
mains power values match. If the included power cord or power adapter does not fit in your
wall outlet, contact your electrician.
24. Do not step on the power cord. Make certain that the power cable does not become kinked,
especially at the mains outlet and/or power adapter and the equipment connector.
25. When connecting the equipment, make certain that the power cord or power adapter is al-
ways freely accessible. Always disconnect the equipment from the power supply if the equip-
ment is not in use or if you want to clean the equipment. Always unplug the power cord and
power adapter from the power outlet at the plug or adapter and not by pulling on the cord.
Never touch the power cord and power adapter with wet hands.
26. Whenever possible, avoid switching the equipment on and off in quick succession because
otherwise this can shorten the useful life of the equipment.
27. To disconnect the equipment from the power mains completely, unplug the power cord or
power adapter from the power outlet.
28. Unplug the power cord and power adapter from the power outlet if there is a risk of a lightning
strike or before extended periods of disuse.
CAUTION
CAUTION:
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Never remove the cover, because otherwise there may be a risk of electric shock. There are no
user serviceable parts inside. Have repairs carried out only by qualified service personnel.
The lightning flash with arrowhead symbol within an equilateral triangle is intended to
alert the user to the presence of uninsulated "dangerous voltage" within the product's
enclosure that may be of sufficient magnitude to constitute a risk of electrical shock.
The exclamation mark within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance instructions.
MANUFACTURER'S WARRANTY & LIMITATION OF LIABILITY
You can find our current warranty conditions and limitation of liability at: https:/ /cdn-shop.adam-
hall.com/media/pdf/MANUFACTURERS-DECLARATIONS_ADAM_HALL.pdf
To request warranty service for a product, please contact Adam Hall GmbH, Adam-Hall-Str. 1,
61267 Neu Anspach / Email Info@adamhall.com / 49 (0) 6081 / 9419-0
PROPER DISPOSAL OF THIS PRODUCT
(WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT)
(Valid in the European Union and other European countries with waste separation)
This symbol on the product, or the documents accompanying the product, indicates that this ap-
pliance may not be treated as household waste. This is to avoid environmental damage or person-
al injury due to uncontrolled waste disposal. Please dispose of this product separately from other
waste and have it recycled to promote sustainable economic activity.
Adam Hall GmbH | Adam-Hall-Str. 1 | 61267 Neu-Anspach | Germany
Phone: +49 6081 9419-0 | adamhall.com
FEATURES
• 230 V Operating voltage, max. 16 A
• 5 Power Twist output jacks
• Metal casing
• 2 x M10 mounting points
• IP protection class 20
INTRODUCTION
The PRO PORT 4 PP is ideal for tidy and targeted power distribution on stages, on trus-
ses and in equipment rigs. The rugged metal housing features a Power Twist power
input jack and 5 Power Twist output jacks, 4 of which are located on top of the distribu-
tor. Two M10 threaded inserts are used for suspension and fixed mounting.
SPECIFICATIONS
Product number AHPROPORT4PP
Product type Power strips
Type Not 19 inch
Number of outlets 1 x Power Twist IN + 5 Power Twist OUT
Power input Power Twist I/O
Operating voltage 230 V
Max. current 16 A
Cabinet material Metal
Color Black
Protection class IP20
Width 297 mm
Height 60 mm
Depth 78 mm
Weight 0.8 kg