Operating Modes - IFM Electronic efector500 PF39 Bedienungsanleitung

2. Operating modes

Run mode:
(Normal operating mode)
When the supply voltage has been applied, the unit is in the Run
mode. It monitors and switches the transistor outputs according to the
set parameters.
The display shows the current system pressure, the red LEDs indicate
the switching state of the outputs.
Display mode:
(Indication of parameters and the set parameter values)
When the "Mode/Enter" button is pressed for a short time, the unit
passes to the Display mode. Internally it remains in the operating
mode. Irrespective of this the set parameter values can be read:
• The parameter names are scrolled with each pressing of the
"Mode/Enter" button.
• When the "Set" button is pressed for a short time, the correspon-
ding parameter value is displayed for approx. 5s; then the unit
returns to the Run mode.
Programming mode:
(Setting of the parameter values)
The unit passes to the programming mode when after the selection of
a parameter value (Display mode) the "Set" button is pressed until the
display of the parameter value is changed. Internally the unit remains
in the operating mode. It continues its monitoring function with the
existing parameters until the change has been terminated.
You can change the parameter value by pressing the "Set" button and
confirm it by pressing the "Mode/Enter" button. The unit returns to
the Run mode when no button has been pressed for 5s.
19