JBSystems Radiant Laser Bedienungsanleitung Seite 7

ENGLISH
CAUTION EYEDAMAGE: Always position the laser in a way that prevents the
audience from looking directly into the laser beams. The installation should assure that
the beam will not strike the audience.
HOW TO SET UP AND CONTROL THE UNIT
MUSIC INPUT SENSITIVITY:
The unit works to rhythm of the beat when used in standalone or master/slave mode
To set the input sensitivity, follow these steps:
 Press the FUNC-button until the display shows "S 0" ..."S 9"
 Press the ENTER-button to confirm your choice.
 Use DOWN and UP button to select a value between "S 0" (very low sensitivity) and "S 9" (high
sensitivity).
 Once the mode is selected, press the ENTER button save it.
You can operate the unit in 5 ways:
1) MUSIC CONTROLLED MODE:
The laser runs a preprogrammed sequence to the rhythm of the music. Select this mode when only 1 laser
is used (standalone) or when the laser is placed as the first (master) unit in a chain with several RADIANT
LASERs.
 Press the FUNC-button until the display shows one of the following: SoN, AUN, Sod, AUd, SoP or AUP.
 Now use the UP or DOWN buttons to select:
o
Son
o
Sod
o
SoP
 Press the ENTER-button to confirm your choice.
You can connect several RADIANT LASERs together: just put the first unit of the chain in one of the sound
activated effect modes and all other units in "Slave mode" (display shows "SLA") to make them all work in
perfect sync!
Note: When no music is detected, the laser output will be shut off (blackout).
JB SYSTEMS
®
(Sound activated random show, containing pattern and grating effects)
(Sound activated grating effects show)
(Sound activated pattern effects show)
5/67
USER MANUAL
RADIANT LASER