Reset Function - Migatronic Rally Mig 161I Kurzanleitung

RALLY MIG 161i CONTROL PANEL
I. Switch on the machine  select process
II. Select type of material and
wire diameter
III. Set one of the following parameters:
welding current, wire feed speed or
thickness of material
IV. Trim the arc length, if required
4 5
1 2 3
1 Selecting welding process MIG/MMA
Selecting welding process TIG under
secondary MMA parameters.
2 Selecting type of material
Press the key until the LED is lit at the
relevant material.
3 Selecting wire diameter
Press the key until the LED is lit at the
relevant wire diameter.

Reset function

Press and hold the key for 5 seconds.
Flashing LED indicates that the relevant
program is reset to factory settings.
4 Primary parameters
Set one of the following
interdependent primary parameters at
your own option: welding current, wire
feed speed or thickness of material.
5 Arc length
The arc length can be adjusted as
required. Press the key under the
symbol and turn the control knob: plus
(+) for a longer arc and minus (-) for a
A B
shorter arc (-9.9 to +9.9).
6
6 Control knob
Adjustment of welding current, wire
feed speed, thickness of material or
arc length. Inching speed is adjustable
during wire inching. If the key for
secondary parameters is active, it
is possible to trim the secondary
parameters.
7
7 Secondary parameters
Press the key until the desired
parameter is shown on the display.
Press key 4 briefly to finish.
A Welding voltage
B Warning – overheating
QUICKGUIDE RALLY MIG 161i
MIG parameters
Set welding current (A)
Arc adjust (electronic choke)
1
MMA parameters
Arc power
Hotstart
Short circuit
Set welding
current (A)
UK
Burnback
See secondary
parameters overleaf
TIG welding