Programming The Remote Control - Becker Centronic SunWindControl SWC510A Bedienungsanleitung

Operating Instructions

Programming the remote control

Note
Ensure that optimum radio reception is achieved.
The threshold values for sun protection and wind control can be set with
the following transmitter: Centronic SunWindControl SWC441A.
Setting the SWC510A to programming mode
a) Set the SWC510A to programming mode by switching on the power
supply
Switch on the power supply.
The SWC510A will remain in programming mode for 3 minutes.
b) Set the SWC510A to programming mode using the programming but-
ton
Press and hold the programming button for 3 seconds.
The SWC510A will remain in programming mode for 3 minutes.
Programming master transmitter
Press and hold the programming button for 3 seconds while in programming
mode.
The system will confi rm the programme setting with a 'nod', i.e. the shut-
ter/awning/blind moves a few centimetres in one direction and then reverses
the same distance.
This confi rmation is hereafter referred to as 'nodding'.
The programming process is now complete.
Note
If a transmitter has already been programmed in the receiver, press the
programming button and hold for 10 seconds.
18