Herunterladen Diese Seite drucken

Philips Vaya Flood LP G2 Installationsaleitung Seite 8

Werbung

A
Ensure that main power supply is off before installing or wiring a
luminaire.
Assurez-vous que l'alimentation principale est coupée avant d'installer ou de câbler un
appareil d'éclairage.
Antes de instalar o cablear una lámpara, asegúrese de que la alimentación eléctrica esté
desconectada.
Accertarsi che la tensione di rete principale sia disattivata prima di installare o cablare un
gruppo di illuminazione.
Zorg dat de stroomvoorziening is uitgeschakeld voordat u een armatuur installeert of be-
drading aanbrengt.
Vergewissern Sie sich, dass die Stromzufuhr unterbrochen ist, bevor Sie einen Beleuchtung-
skörper installieren oder ans Stromnetz anschließen.
フィクスチャを設置または配線する前に、 主電源がオフであることを確認してください。
对灯具进行安装或接线时,需确保主电源已关闭。
B
Do not attempt to install or use a luminaire until you read and
understand the installation instructions and safety labels.
Assurez-vous d'avoir lu et compris les instructions d'installation et les autocollants de sécu-
rité avant d'installer ou d'utiliser un appareil d'éclairage.
No intente instalar o utilizar una lámpara sin previamente haber leído y comprendido las
instrucciones de instalación y las etiquetas de seguridad
Non provare a installare o utilizzare un gruppo di illuminazione se non sono state lette e
comprese le istruzioni per l'installazione e le etichette di sicurezza.
Probeer geen armaturen aan te brengen of te gebruiken voordat u de plaatsingsinstructies
en veiligheidslabels hebt gelezen en begrijpt.
Installieren oder verwenden Sie einen Beleuchtungskörper erst, nachdem Sie die Installa-
tionsanweisungen und Sicherheitsetiketten gelesen haben.
置手順と安全ラベルを読み理解してから、 フィクスチャの設置または使用を始めてください。
阅读并理解安装说明和安全标签之前,切勿试图安装或使用灯
B
Do not hot swap luminaires. Ensure that power to the series is off
before connecting or disconnecting individual luminaires.
Ne remplacez pas les appareils d'éclairage à chaud. Assurez-vous que l'alimentation série
est coupée avant de brancher ou de débrancher chaque appareil d'éclairage.
No sustituya lámparas mientras estén calientes. Asegúrese de que la alimentación eléctrica
de toda la serie de lámparas esté desconectada antes de conectar o desconectar una
lámpara individual.
Non sostituire a caldo i gruppi di illuminazione. Accertarsi che l'alimentazione in serie sia
disattivata prima di collegare o scollegare i singoli gruppi di illuminazione.
Vervang een armatuur niet terwijl deze aan is. Zorg dat de voeding naar de reeks is uitges-
chakeld voordat u afzonderlijke armaturen aansluit of loskoppelt.
Tauschen Sie einen Beleuchtungskörper nicht im eingeschalteten Zustand aus. Vergewissern
Sie sich, dass die Stromzufuhr zu einer Serie von Beleuchtungskörpern unterbrochen ist,
bevor Sie einzelne Beleuchtungskörper anschließen oder vom Stromnetz trennen.
電源を入れたままフィクスチャを交換しないでください。 個々のフィクスチャを接続または取り外す前に、
直列フィクスチャへの電源がオフであることを確認してください。
切勿热插拔产品。连接或断开单个灯具之前,必须确保供该系列之电源已关闭。
B
The luminaire shall, under no circumstance, be covered with
insulating material of any kind.
Le luminaire ne doit, en aucune circonstance, être couvert par un matériau isolant de
quelque sorte que ce soit.
La luminaria no debe estar cubierta en ningún caso de material aislante de ningún tipo.
In nessun caso l'apparecchio deve essere coperto con materiale isolante di qualunque tipo.
De lamp mag onder geen enkele omstandigheid afgedekt worden met ongeacht welk
isolatiemateriaal.
Die Beleuchtung darf nie durch Isolierstoffe jeglicher Art bedeckt sein.
いずれの場合においても、 照明器具は任意の種類の絶縁素材で被 覆してください。
无论在何种情况下,该灯具控制系统都不能被任何类型的绝缘材料所包裹。
B
Do not use a luminaire if the lens, housing, or power cables are
damaged.
N'utilisez pas un appareil d'éclairage si la lentille, le boîtier ou les câbles d'alimentation sont
endommagés.
No utilice una lámpara que presente daños en el cristal o plástico, estructura o en los cables
de alimentación eléctrica.
Non utilizzare un gruppo di illuminazione se il gruppo ottico, l'alloggiamento o i cavi di
alimentazione sono danneggiati.
Gebruik een armatuur niet indien de lens, behuizing of voedingkabels zijn beschadigd.
Verwenden Sie den Beleuchtungskörper nicht, wenn das Lampenglas, Gehäuse oder ein
Netzkabel beschädigt ist.
レンズ、 ハウジング、 または電源ケーブルが損傷している場合は、 フィクスチャを使用しないでください。
如果灯镜片、灯壳或电线受损,切勿使用产品。
Copyright © 2017 Philips Lighting Holding B.V. all rights reserved.
All rights reserved. Chromacore, Chromasic, CK, the CK logo, Color
Kinetics, the Color Kinetics logo, ColorBlast, ColorBlaze, ColorBurst,
eW Fuse, ColorGraze, ColorPlay, ColorReach, iW Reach, eW Reach,
DIMand, EssentialWhite, eW, iColor, iColor Cove, IntelliWhite, iW,
iPlayer, Optibin, and Powercore are either registered trademarks
or trademarks of Philips Lighting Holding B.V. in the United States
and / or other countries. All other brand or product names are
trademarks or registered trademarks of their respective owners. Due
to continuous improvements and innovations, specifications may
change without notice.
B
Do not use a luminaire for any voltage for which it is not rated.
Do not exceed the specified voltage and current input for any lumi-
naire.
N'utilisez pas un appareil d'éclairage sous une tension autre que la tension nominale. Ne
dépassez jamais la tension et la consommation de courant spécifiées pour un appareil
d'éclairage.
No conecte la lámpara a un voltaje distinto al especificado. No sobrepase el voltaje o la
corriente eléctrica especificados en ninguna de las lámparas.
Non utilizzare un gruppo di illuminazione su una rete elettrica non classificata. Non superare
la tensione e la corrente di ingresso specificate per il gruppo di illuminazione.
Gebruik een armatuur niet bij een spanning waarvoor deze niet is bestemd. De opgegeven
spannings- en stroomwaarden mogen voor een armatuur niet worden overschreden.
Verwenden Sie den Beleuchtungskörper nicht bei Stromspannungen, für die der Beleuch-
tungskörper nicht bestimmt ist. Die für einen Beleuchtungskörper angegebene Spannung
und der angegebene Eingangsstrom dürfen nicht überschritten werden.
規定以外の電圧でフィクスチャを使用しないでください。 フィクスチャに供給される電圧および電流が、
指定された値を超えないようにしてください。
切勿在任何非额定电压的情况下,使用产品。切勿超出灯具规定的电压与输入电流.
B
The luminaire is suitable for direct mounting on flammable struc-
tural materials, i.e., wood, etc.
Le luminaire peut être directement monté sur des matériaux de résistance inflammables
tels que le bois.
La luminaria se puede montar directamente sobre materiales estructurales inflamables,
como puede ser la madera.
L'apparecchio è adatto a essere montato direttamente su materiali strutturali infiammabili
come il legno.
De lamp is geschikt voor directe montage op brandbare bouwmaterialen als hout.
Die Beleuchtung ist für direkte Installation auf entzündbaren Strukturmaterialien wie Holz
geeignet.
照明器具は、 木材゙などの可燃性の材質に直接取り付ける場合に 適しています
该灯具控制系统适合直接安装在木料等可燃性的结构材料上。
B
The luminaire power and data cables are not replaceable. If
the external cables are damaged, the lighting luminaire needs to be
replaced.
L'alimentazione del gruppo di illuminazione e i cavi per trasmissione dati non sono sostitu-
ibili. Se i cavi esterni sono danneggiati, è necessario sostituire il gruppo di illuminazione.
Les câbles d'alimentation et de données de l'appareil ne sont pas remplaçables. Si les
câbles externes sont endommagés, l'appareil d'éclairage doit être remplacé.
La alimentación del aplique y los cables de datos no pueden sustituirse. Si los cables exter-
nos están dañados, debe reemplazarse el aplique.
De stroomvoorziening van het armatuur en de datakabels kunnen niet vervangen worden.
Als de externe kabels beschadigd zijn, moet de lichtarmatuur vervangen worden.
Strom- und Datenkabel der Halterung können nicht ersetzt werden. Wenn die externen
Kabel beschädigt sind, muss die Leuchtenhalterung ausgetauscht werden.
器具の電源ケーブルとデータケーブルは交換可能ではありません。 外部ケーブルが損傷した場合は、 照
明器具を交換する必要があり ます。
灯具电源电缆和数据电缆不可更换。如果外部电缆损坏,则需要更 换灯具。
C
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause interference in which case the user will be required to correct the
interference at his own expense.
C
This digital apparatus complies with Canadian ICES-003 Cet appar-
ell numrique de la class A est conforme á la norme NMB-003 du Canada.
D
产品在220V条件下: 产品额定输入电流最大为230mA, 功率因数大于
0.90。
Philips Color Kinetics
www.philips.com/colorkinetics

Werbung

loading