Software Settings - Butler Hapro LUXURA SOUND AROUND Anleitung

ENGLISH

Software settings

Note: If you have bought this product together with your tanning unit, you don't
have to change the software settings .
The "SoundAround" system has been supplied with default settings which are usually more
than adequate . However, it is possible to change several relevant settings, such as:
1 . Number of music channels
2 . Amplifier input signal
3 . Starting volume
4 . High tones
The following description clarifies the ways in which the various settings can be changed .
Please take note that these are the settings that are performed in a general program menu .
These settings may only be adjusted by a Hapro dealer .
Main settings menu
6 - Facial
7 - Bodyfan
8 - Headfan
9 - Audio
9 - Audio settings menu
1 - Volume channel 1
2 - Volume channel 2
3 - Volume channel 3
4 - Volume channel 4
9 - Audio settings menu
9 - Volume MP3
10 - Stand-by volume
11 - Stand-by channel
12 - Start channel
66
5 .
6 .
7 .
8 .
Select parameter "9 . Audio" from the "main settings
menu" to enter the "audio settings menu" .
Parameters 1- 4 , "Volume channel"
Use these parameters to set the amplification of the
26
incoming signal . The default setting is 26 .
26
26
26
9 - Volume Mp3.
The volume of the MP3 player, if present, can be
26
adjusted here . The default setting is 26 .
0
1
1
10 - Stand-by volume.
The volume of the speakers when the device is in stand-
by mode can be adjusted here . The default setting is 0 .
Low tones / bass
SmartVoice
SmartVoice language choice
MP3 input
To access the settings menu, the
sequence shown adjacently must be
entered from left to right .