Peltor Dect-Com Bedienungsanleitung Seite 4

least 5 seconds. The LED on the handset starts
flashing and you will hear a long steady tone
in the headset. The registration can take up to
a minute. When the handset is registrated on the
DECT base, the green LED on the Base Unit will
light continuously and the LED on the handset
will give one short flash every 3 seconds. The
handset is now connected to the conference and
ready for use.
2.0 DISCONNECT FROM CONFERENCE:
Press the CONNECT button briefly to disconnect
the handset from the conference with the other
handsets. The LED starts flashing (two short
flashes every 3 seconds).
2.1 CONNECTION TO CONFERENCE:
Press the CONNECT button briefly to connect the
handset to the conference with the other handsets.
The LED starts flashing (one short flash every 3
seconds).
2.2 HIGH-LEVEL SOUND IN THE HEADSET:
Press VOL+ and VOX+ at the same time for at
least 5 seconds, and a high-level sound function
is activated in the headset. You will hear a short
tone in the headset. This function is useful if the
background noise is very high.