AXTON A500DSP Einbau & Bedienungsanleitung Seite 5

EQ Preferences
After the app has connected successfully,
the EQ menu appears automatically for you
to make your preferences.
With this parametric 7-band equalizer you
can correct the frequency response with
pinpoint accuracy.
In the line „f0" tap on the band you want.
A pop-up window appears for you to enter
the value of the center frequency you want.
Confirm with „OK".
In the line „Q" tap on the band you want.
A pop-up window appears for you to enter
the value of the quality factor you want.
Confirm with „OK". The quality factor (Q
factor) determines the effect of the EQ filter
(bandwidth) on the frequency band around
the chosen center frequency f0.
Example1: f0 = 1000 Hz
desired bandwidth of EQ filter = 1000 Hz
(i.e. 500 Hz – 1500 Hz) Q = 1
Example2: f0 = 1000 Hz
desired bandwidth of EQ filter = 200 Hz
(i.e. 900 Hz – 1100 Hz) Q = 5
Q factors from 0.3 to 9.9 are possible.
– 8 –
If required, you can choose independent
equalizer preferences for the front and rear
channels. Simply press Front P.EQ or Rear
P.EQ.
When you have done the preferences,
touch the „Save to Amplifier" button
to transfer the preferences to the amplifier.
During the saving process do not switch off
the amplifier as this may lead to malfunc-
tion and/or damage. You can also save
the preferences on your smartphone. To
do this, press the „Save on Phone" button
, and enter the desired filename.
Press
Front P.EQ
or Rear P.EQ.
Favorites
Press the menu button at the top right,
and select one of the favorites 1 – 5. To
reset all settings to „0", press the „Reset"
button . If you just want to try out the
presets and then go back to your personal
preferences, exit without saving the app,
and then restart. The app will then load
your saved preferences from the amplifier.
Press menu
button at the
top right
– 9 –