Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TEST
• Connect the mains to the thermostat > the green LED should light up.
• Set both potentiometers to their centre position.
• Adjust RV1 until the relay energises or de-energises; LED LD4 should also light up or
dim.
• Push SW1, to make the thermostat switches from day mode to night mode > the yellow
LED should flash.
• Adjust RV1 until the relay energises or de-energises; LED LD4 should also light up or
dim.
See the user manual (p. 20) for adjusting the scale.
If you do not have the Velleman housing, use the graduated scale that is show in the parts
list.
Mount in the optional housing (BTT2000W):
• Slide the PCB into the groove at the housing until it clicks (check the position of the
grooves with response to the PCB).
• Place the cover onto the housing and secure it using two screws.
8
Werbung
