Adding To Already Existing Recordings; Remaining Recording Time; Vos - Voice Controlled Recording - Audio VR500 Bedienungsanleitung

7.7

Adding to already existing recordings

It is also possible to make retrospective additions to already existing recordings.
Select the required recording that you want to add to and press the PLAY/STOP button. The
recording will be played back.
Press the REC/STOP button for 2 seconds at any point. The message
"Add-R" will appear in the display and the additional recording will start im-
mediately.
Note: The new recording will always be appended to the end of the selected recording. Un-
der no circumstances will parts of the old recording be erased.
The recording is terminated by pressing the REC button again.
7.8

Remaining recording time

The remaining recording time is shown in the lower part of the display between the indicators E
and F. The fewer bars there are visible, the less recording time there is remaining.
You can check the remaining memory capacity while a recording is being made. To do this, hold
the PAUSE/HEAR button pressed for 2 seconds and the display will show the remaining re-
cording time in minutes and seconds for ca. 10 seconds.
7.9

VOS - Voice controlled recording

When VOS is switched on, any pauses that occur during recording will not be recorded. When
you are not speaking, the VoiceRecorder switches the recording to Pause (display shows
"VOS"). When you speak again, the unit continues recording automatically.
Switching VOS on or off
Press the MENU button three times and choose whether you want to switch
the function on or off by means of the SEARCH buttons. When the VOS
mode is switched on, the VOS indicator will appear in the display.
- Operation -
29