Innogy SHC Bedienungsanleitung Seite 4

EN
Function
The central unit is used to control and
manage your SmartHome devices and is an
essential part of the setup required to use
your SmartHome system. The central unit
saves the settings and configurations of
the individual devices along with any
scenarios that have been created. This
ensures that local control is properly sup-
ported even if the connection between the
central unit and data centre fails.
Hazard warning
• Do not open the central unit. It does not
contain any parts to be serviced by the
user. If a fault occurs, please contact our
Customer Service.
• Only operate the device indoors. Avoid
the influence of humidity, dust, sunlight
and other heat radiation.
• In order to prevent damage to the
device, only use the original power pack
included in delivery for supplying power.
Requirements
• Permanent internet connection
• Current-generation smartphone, tablet
or PC with browser
Commissioning
1 To use the central unit as a free-standing
device, mount the supplied stand on the
rear of the central unit. To do this, slide
the stand into the grooves on the rear of
the central unit until the stand will go no
further.
To mount the central control unit on a
wall, drill two holes with a diameter of 5
mm into the wall, leaving a gap of 129
mm between them.
2 First, insert the dowels into the drilled
holes and then screw the screws into the
dowels until approximately 1.5 mm is
left protruding. Drag the central unit
over the screw heads downwards until it
is firmly attached.
3 Connect the central unit to a free port on
your internet router using the enclosed
network cable.
4 Connect the connector power pack inclu-
ded in delivery to the central unit and
plug it into an easily accessible 230V
socket.
5 The latest software is downloaded from
the data centre and installed. An 8-digit
PIN is then displayed, which is visible
and valid for 60 minutes.
6 Download the latest SmartHome app to
your smartphone or tablet or open
SmartHome in the browser and follow
the instructions for initial installation
and commissioning.
General information
eQ-3 Entwicklung GmbH hereby declares
that this device meets the basic require-
ments and the other relevant regulations
laid down in Directive 1999/5/EC.
You can find the complete declaration of
conformity at:
www.eq-3.de/service/downloads.html
eQ-3 Entwicklung GmbH,
Maiburger Str. 36,
D-26789 Leer
4