Venting Program; Installation - WITA go.future LCD 40 series Einbau- Und Betriebsanleitung

Operating instrutions
IV Venting program
By pressing and holding the
This program operates the pump alternately with various rotational speeds.
This results in the following indication on the display:
The first segment is a moving icon to indicate
that the program is running.
In segments 2 and 3, it is indicated which one of the
9 phases the program is currently in, starting in phase 9 and counting down. Each phase takes
about 1 minute. After completion of the entire program, it will return to the display of the
normal operation mode.
The venting program can be cancelled prematurely by pressing and holding the

8 Installation

Fig. 1
Fig. 2a
32
WITA go.future LCD 40-XX | 60-XX
-button, the venting program is initiated.
Carry out voltage-free mounting with the pump motor in a
horizontal position (directional arrow on the pump housing
indicates the direction of flow) (Fig. 1). During heat insulation
work, make sure that the pump motor and the electronics
housing are not insulated. If the installation position should
be changed, the motor housing must be turned as follows
(Fig. 2a to 2d):
• Loosen hexagon socket bolts
• Twist off motor housing
• Screw in hexagon socket bolts again and tighten.
Fig. 2b Fig. 2c
-button.
Fig. 2d