Power Supply; Switch On / Off - Laserworld Ecoline El-100Rg Micro Rc Bedienungsanleitung

7. Operation

7.1 Power supply

Connect your EL-Micro with the line adapter and connect it with the power supply.
Please make sure that you are using the correct voltage. False voltages could destroy
the device. Please use the voltage specified at the end of this manual. Don't focus
the front of the laser on people while installation.
The following functions can be set:

7.2 Switch on / off

Set the switch on the back side of the laser on "1 On" to switch the device on or
"4 Off" to switch the device off. The auto mode is active when "1 On" is set. Please
disconnect the device from the power supply if you don't need it for a longer period.
7.3 Stroboflash
Set the switch on "2 Stroboflash" to activate the flash effect. The laser output will be
interrupted in certain intervals.
7.4 Voice Controller
The music mode is active when "3 Voice Controller" is activated.
7.5 Remote control
mode selection
strobe effect
The EL-100RG Micro RC can be controlled via a remote control unit. All settings can
be done by this. Please compare the operation steps 7.2 - 7.4 to make the settings
with the remote control unit.
on / off button
color settings
speed settings