Establishing A Bluetooth Connection; Ending A Bluetooth Connection; Connecting To An External Device With The Included Cable - Yamaha HPH-W300 Bedienungsanleitung

Establishing a Bluetooth connection

Turn on the headphones.
A Bluetooth connection is established with the most-recently connected Bluetooth device.
Note
• Some Bluetooth devices may not connect automatically.
• If the Bluetooth device does not connect to the headphones automatically, operate the device
to connect to the headphones.
• After you turn off the Bluetooth setting of the Bluetooth device, a Bluetooth connection is not
automatically established with that device when you turn on the power of the headphones.
• The headphones can establish a Bluetooth connection with two devices simultaneously
(multi-point connection). To establish a Bluetooth connection with the second device, perform
the process also on that Bluetooth device. Audio from the connected Bluetooth devices can be
switched by playing or stopping music from the connected Bluetooth devices.

Ending a Bluetooth connection

If a Bluetooth connection exists, you can end it in either of the following ways.
- Turn off the power of the headphones.
- End the Bluetooth connection on the Bluetooth device.

Connecting to an external device with the included cable

The headphones feature an input connector on
the left housing, allowing you to connect an
external device (with the included 3.5 mm ste-
reo mini plug cable) and use the headphones
as you would conventional ones.
NOTICE
Be sure to use the included 3.5 mm stereo
mini plug cable to connect an external device.
Note
If a cable is connected to the input connector
while the headphones are being turned on,
the headphones automatically turn off. To
turn on again after disconnecting the cable,
slide the power switch to the off position once
and turn on again.
Left side (L)
3.5 mm stereo mini plug cable
EN 9
HPH-W300
External input
jack
(included)