Start Up; Dosage; Special Accessory - Maspo Skinfresh HT 220 Gebrauchsanweisungen

Start up

Place the appliance on a stable surface
(usually a table). Connect the unit only to a
240 V AC power source.
The length of the collagen session is set at
the electromechanical timer by rotating the
knob. The unit switches on automatically
when this knob is set.
The lamp takes about three minutes to reach
full power.
The lamp will not light if it is hot. Allow it
to cool for three to four minutes before
restarting the appliance.
Assume a comfortable position after setting
the proper time (see the following section);
the face should be 15-20 cm (6-8 inch) from
the fi lter glass.
Radiation the upper body will require a
distance of 50 cm. The light will then cover
the area from the head to the waist.
Unplug the lead after each use.
Allow the appliance to cool down for at least
15 minutes before storing it.

Dosage

Read instructions carefully and observe
the exposure instructions.
Please remain a loof at 15 cms minimum
for your face.
minimum 15 cm

Special accessory

A wheeled stand has been developed es-
pecially for this unit; both the height and the
tilt angle are adjustable. It can be rolled up
close to a chair, couch or bench. Order No.
91.7480.
GB 17