Multiplex MULTIcont BL-XX S-BEC Bedienungsanleitung Seite 7

3. Select direction of rotation
(triple beep, continuously repeated)
3.1 For reverse rotation
→
stick to full-throttle
position
OR:
For standard rotation*
→
stick to motor OFF
position
3.2 Stick to centre position
4. Select motor cut-off type
(quadruple beep, continuously repeated)
4.1 For motor cut
(hard stop)
→
stick to full-
throttle position
OR:
For power
reduction *
→
stick to motor
OFF position
4.2 Stick to centre
position
5. Select motor start-up behaviour
(five-times beep, continuously repeated)
5.1 For soft-start *
→ stick to full-throttle
position
OR:
For standard start-up
→ stick to motor OFF
position
5.2 Stick to centre position
6. Select automatic timing
(six-times beep, continuously repeated)
6.1 For automatic timing ON*
→
stick in full-throttle
position
OR:
For automatic timing OFF
→
stick to motor OFF
position
6.2 Stick to centre position
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten • www.multiplex-rc.de
MULTIcont BL-XX S-BEC brushless controllers
⇒ Confirmation signal
emitted
⇒ Confirmation signal emitted
LiPo batteries:
Motor off at 3.0 V / cell
NiXX batteries:
Motor off at 6.0 V!
LiPo batteries:
Motor speed is reduced at 3.2 V /
cell throttle stick to motor OFF
position open throttle
completely at 2.9 V / cell
NiXX batteries:
Motor speed is reduced at 6.0 V
throttle stick to motor OFF position
open throttle motor off
completely at 5.8 V / cell
⇒ Confirmation signal
emitted
Motor start-up time in
helicopter mode:
approx. 7.0 sec
in fixed-wing mode:
approx. 1.3 sec
Motor start-up time in
helicopter mode:
approx. 2.0 sec
in fixed-wing mode:
approx. 0.2 sec
⇒ Confirmation signal
emitted
Operating Instructions
7. Select manual timing
→
only if automatic timing was previously set to OFF
(seven-times beep, continuously repeated)
7.1 For "hard" timing
(22 - 30 degrees)
→
stick to full-throttle
position
OR:
For "soft" timing (7 degrees)
→
stick to motor OFF
position
7.2 Stick to centre position
8. Select pulse frequency
(eight-times beep, continuously repeated)
8.1 For 8 kHz pulse frequency
→
stick to full-throttle
position
OR:
For 16 kHz* pulse
frequency
motor off
→
stick to motor OFF
position
8.2 Stick to centre position
9. Select model type
(nine-times beep, continuously repeated)
9.1 For helicopters (Governor
Mode)
→
stick to full-throttle
position
OR:
For fixed-wing models*
→
stick to motor OFF
position
10. Quitting programming mode
10.1 Stick to centre position
10.2 Stick to motor OFF position
* Default setting / as supplied
7. S-BEC = SWITCHING BEC
MULTIcont BL-XX S-BEC speed controllers are equipped with a
high-performance switching regulator BEC system: the receiver
and servos are fed power from the flight battery via the regulator;
no separate receiver battery is required.
Never connect a separate receiver battery!
Please note that the MULTIcont BL-XX S-BEC speed controller's
S-BEC power supply can only deliver a limited current to the
receiving system in the model:
⇒ Confirmation signal
emitted
Recommended for
out-runners
Recommended for
in-runners
⇒ Confirmation signal
emitted
⇒ Confirmation signal
emitted
Governor mode = constant
rotational speed maintained
In Governor mode the
Brake is automatically
switched OFF, even if you
previously selected Brake
On
⇒ Rising tone sequence
⇒ Rising tone sequence
sounds twice: the controller
is ready for use, the altered
parameters have been
stored
Page 3/4