Operating Range; Before Operation; Operation; Maintenance - Mantis 8560-00-38 Gebrauchsanweisung

oPeRaTIng Range

This Blower/Vacuum device must only be used to
blow away or vacuum dry and light materials as e.g.
dry leaves, small branches, and pieces of paper. The
vacuuming of heavy materials as e.g. metal, stones, big
branches and broken glass is prohibited.

befoRe oPeRaTIon

Unpacking
1. Take all parts out of the packaging.
2. Check all parts for transportation damages. If you
detect any damages or if parts are missing, please
contact your dealer.
assembly
attention ! always pull the plug and switch
the device off, before you assemble the
device or replace parts.
blowing
1. Align the grooves on the blower tube with the grooves
on the blower outlet. Push the blower tube onto the
blower outlet until it locates in the right position (Fig. A).
2. Fix the adjustable shoulder harness on the top han-
dle, put the blower on (Fig. B).
3. Assembly the power cord according to the picture
c1,c2
operating instruction
1. Move the power off/on switch to the ON position (Fig. D)
2. Adjust speed control until the speed is acceptable
(Fig. E)
3. Direct the blow tube toward the leaves (Fig. F)
vacuum mode
1. Press the button of the blower tube downward, draw
the tube out of housing (Fig. G)
2. Clear the tube outlet by using the brush to prevent
the tube from becoming blocked when vacuuming the
leaves (Fig. H)
3. Align the blower tube lower with the grooves on the
blower tube upper. Push the blower tube lower onto
the blower tube upper until it locates in the right posi-
tion (Fig. J)
4. Unload the Impeller Guard (Fig. K)
5. Align the blower tube with the mark "Δ", insert the
blower tube to the housing, and rotate the blower
tube about 90 degree (Fig. L2), the hook should be
locked according to the Fig. L3.
6. Put the bag hook on the cable cleat of blower tube,
and insert the bag to the housing (Fig. M1 and M2)

oPeRaTIon

Use the device only for applications described in the sec-
tion Operating Range.
15
Electric Blower/Vac Operator's Manual
attention! Thrown-about objects may cause
serious injuries of the operator or other per-
sons. always wear eye and ear protectors as
well as a proper working dress. spectators
must keep a distance of at least 5m.
on/off switch
1. Connect the power and move the power off/on switch
to the ON position (Fig. N).
Direct the suction tube toward the leaves and suck them
in (Fig. P).

MaInTenanCe

Apart from keeping the vacuum blower clean and un-
blocked, there are no user maintenance procedures to
be carried out. Refer to qualified service personnel if any
repairs are required.
Cleaning
- Remove the debris bag down and clear leaves in joints
of debris bag by using the brush (Fig. Q)
- Move the zipper and tip out the debris (Fig.R)
- Remove the Impeller Guard down and clear leaves in
the Impeller by using the brush (Fig. S1).
- Use the brush to clear leaves in the mouth of blower
tube (Fig. S2)
- Clear the surface of housing (Fig. S4)

RePaIR seRvICe

Repairs to electric power tools should only be carried out
by specialist electrical personel.
UK
Mantis UK Limited
Orchard House
Hempshaw Lane
Stockport
Cheshire SK1 4LH
Phone - 4401614741525
europe Mantis France SARL
20 rue des Garennes
57155 Marly
France
Tél 330387628888
Or contact your local Mantis authorised dealer.
WasTe DIsPosal anD envIRonMenTal
PRoTeCTIon
If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but dis-
pose of it in an environmentally friendly manner.
Please dispose of the device itself at an according col-
lecting/recycling point. By doing so, plastic and metal
parts can be separated and recycled. Information con-
cerning the disposal of materials and devices are avail-
able from your local administration.