Inserting Batteries; Status Led - Phottix Strato Benutzerhandbuch

1. Parts
Strato receivers are designed to work in Manual
Exposure mode and have no TTL functions.
2. Tip
Turn off all devices – flashes/strobes, cameras,
and Phottix Strato receivers - when connecting
and disconnecting devices.

3. Inserting Batteries

Press the battery cover in while pushing it away
from the Strato transmitter or receiver. The bat-
tery cover will snap open.
Remove the battery cover from the Strato.
Insert AAA batteries.
Replace the battery cover and push back into
the locked position.
4
4. Test / Shutter Button
The Test / Shutter Button will test fire remote
flashes/strobes or take a photo when the Phot-
tix Strato is used as a wireless shutter release.
To Test: Press the transmitter or receiver Test /
Shutter Button – flashes connected to Phottix
Strato receivers on the same channel will fire.
For Wireless Shutter Release: See Using
the Strato as a wireless shutter release below

5. Status LED

The Status LED on the front of the Phottix Strato
transmitter will turn solid green when autofo-
cusing (on camera or as a wireless remote) and
turn red when sending a signal
The Status LED on the Phottix Strato receiver
will flash green while the power is on and idle.
The LED will turn red when a signal is received
from the transmitter.