Repair Service; In The Case Of Technical Problems - Texas KSE 2100-35 Gebrauchsanweisung

the chain is not used again immediately, it must be
treated with service spray or a customary anticorrosion-
spray.
• Only in case of use of biological oil: As some biological
oils may tend to incrustation after a time, the oiling
system should be rinsed thoroughly before storing the
chain saw for a longer period. Therefore, please fill half
of the oil reservoir (about 50 ml) with chainsaw cleaner
and close it as usually. Then switch on the chainsaw -
without bar and chain being mounted - and keep it
running until the total rinsing liquid has evapurated
through the oil opening of the chain saw. Before using
the chain saw again, it is absolutely necessary to refill
the oil reservoir.
• Do not store the saw outdoors or in damp and moist
areas.
• Check all the chain saw parts, in particular the chain,
bar and sprocket, of wear after every use.
• Ensure that the chain tension is correct. If the chain is
too loose, it may come off during use and lead to injuries.
The chain must be replaced immediately if it is damaged.
The cutting teeth must be at least 4 mm long.
• Check the motor housing and power cable after every
use for damage. If there is any sign of damage, have
the chain saw checked by a specialised workshop or
the works after-sales service.
• Check the oil level and lubrication of your chain saw after
every use. Insufficient lubrication leads to damage to the
chain, bar and motor.
• Check how keen the chain is every time before you use
the chain saw. A blunt chain will cause overheating of
the motor.
• Sharpening a saw chain requires experience and
specialised knowledge. We therefore recommend to
have sharpening carried out by a specialised workshop.

In the case of technical problems

• The machine does not start up: Check whether the
current socket is live. Check whether the power cable is
undamaged. If neither case applies, take the chain saw
to a specialised workshop or the works after-sales
service.
• Chain does not run: Check position of handguard (see ill.
7). Chain only runs if handguard brake is released.
• Sparks fly at the motor: Motor or carbon brushes
damaged. Take the chain saw to a specialised work-
shop or the works after-sales service.
• Oil does not flow: Check the oil level. Clean the oil flow
openings in the bar (see also the corresponding hints of
"Maintenance and servicing). If this is not successful,
take the chain saw to a specialised work-shop or the
works after-sales service.
Attention: Any maintenance or repair work going
beyond that described in these Operating Instruc-
tions may only be carried out by authorised
persons or the works after-sales service.
Attention: If the power supply lead of this device
shows any defects, the lead must be replaced by
an authorized repair shop only or through the
manufacturer's own service personnel, as this
work requires special tools.

Repair Service

Repairs to electric power tools should only be carried out
by specialist electrical personnel.
Texas
Andreas Petersen Hojby ApS
Knullen 2
DK – 5260 Odense S
Tel.: 0045 - 6395 5555
Fax: 0045 - 6395 5558
GB-5
06/2004