Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Daily use of the thermostat
4-event clock mode
The day has been split into 4 events describing a typical day. When the thermostat is in 4-event mode it will automatically adjust the temperature according
to the required temperature to the required time. As standard the thermostat has 5 days with 4 events, and 2 days with 2 events. Programming see 3.
4-event clock mode:
Comfort mode:
☞
5 secs.
☞
Manual mode:
☞
5 secs.
☞
3. Programming
4-event time and temperature
For each event, the start time and required
temperature must be set.
For example, in the morning you wish the heating to
start at 07:00 and the temperature to rise to 21˚C.
Press OK (
) button for 3 seconds and the start time
is displayed. Change this to 07:00 with the
UP ( ) or DOWN ( ) button. Press OK (
The temperature is now displayed. Change this to 21˚C
with the UP (
) or DOWN ( ) button.
Press OK ( ) button to confirm. This action can now
be repeated for the second event.
These settings will be valid with days 1-5 showing on
the display. To program the days 6 and 7, repeat the
above. Days 6 and 7 are usually Saturday and Sunday,
and only have two events.
The temperature can be set within the range of +5 to
+40˚C. It is also possible to select the heating OFF at
that event by reducing the setting to 5˚C, and then
pressing the ( ) once more.
The clock function symbol (
) and one of the 4-event symbols (
Programming see 3.
Temporary override
To temporarily override the temperature in the 4-event schedule program, press the UP (
once, to show the temperature, and press again to increase or decrease the temperature. The display will flash for
5 seconds, and will then revert to the time. The override will operate until the next programmed event when the
unit will resume the automatic programme.
Cancel comfort mode
To cancel the override state, press the OK ( ) button twice.
Permanent override:
During holidays, the scheduled 4-event program can be overridden.
Press the OK (
) button, and then the UP ( ) or DOWN ( ) button until the override temperature is set.
The unit will now operate to this temperature permanently.
Cancel manual mode
To cancel the permanent override state press the OK ( ) button once, and the unit will resume automatic function.
Press OK ( ) button for 3 secs. to begin programming
Day 1 - 5
) to confirm.
Day 6 - 7
☞
☞
☞
☞
☞
☞
☞
☞
☞
☞
☞
☞
) will be indicated.
) or DOWN (
) button
: Time and temperature
: Time and temperature
: Time and temperature
: Time and temperature
: Time and temperature
: Time and temperature
6
Werbung
