Werbung
Verfügbare Sprachen
Verfügbare Sprachen
circuit diagram
trouBleshooting
problem
ursache
The compressor runs for
The voltage is not in the
1-5 minutes and stops
normal range
The compressor runs but
The refrigerant has leaked
inner liner does not get
The system is blocked
cold
The inner liner is very cold
The ice layer on the evapo-
and the compressor runs
rator is too thick
continuously.
The door is being opened
and closed too frequently
The condenser is not well-
ventilated. The controller
is faulty
The compressor does not
"+" and "-" are switched.
run
The controller is faulty(the
power indicator is not on)
Bedienungsanleitung_Kühlschrank_Multi.indd 14-15
The freezer is noisy
abhilfe
Switch off power
and restart when
moVement and installation
power is normal
• When moving the freezer, the angel between the cabinet and the ground should not
Contact your local
be less than 45
dealer
• Position the freezer in a dry and well-ventilated place. Keep the freezer away from
direct sunlight, heaters and corrosive gases.
Defrost
• The normal operation of the freezer depends on the heat radiation of the condenser.
For the initial use, the packing foam must be taken off and at least 150mm space
must be left around the freezer.
The door should be
opened as little as
possible
Select a well-venti-
lated place
Rectify
Contact your local
dealer
The thermostat is set too
high; the ambient tempera-
ture is too low.
The freezer is not placed
properly.
Some parts come loose.
The pipes are touching.
in order to protect the compressor and refrigerating system.
o
Use as a freezer
Make the freezer
level
Contact your local
dealer
06.12.12 11:40
Werbung
