Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
1.
Put the receiver near the audio adjustor, connect with power mains and the signal
protected cord with AF (A) / AF (B) or mixed AUX out. And then connect with the
amplifier or the microphone of the audio adjustor (MIC IN). Spread out two antennas
completely.
2.
Press the power switch; the power indicator will turn on. The receiver will enter
standby. Please note, for optimal reception do not put the receiver in a corner, or
near obstacles that might reduce range of the receiver.
3.
Unscrew the microphone's cover of battery case, install the battery correctly, then
screw it back. (Please not the correct polarity).
4.
Put the microphone switch to ON position. The signal indicator will turn on.
5.
If the signal on the microphone is off or dusky, the battery level is low. Replace
batteries for better reception.
Battery replacement
Change batteries whenever you notice the sound quality has deteriorated, the signal is
unstable or the effective distance has shortened.
SPECIFICATION
Channel
Microphones
Carrier frequency
range
Frequency stability
Modulation Mode
Maximum deviation
range
Frequency response
S/N Ratio
Audio dynamic range
T.H.D.
Range
Temperature range
Owner's manual
MIK0139
single
1x handheld mic + 1
1x handheld mic
OVERALL
MIK0140
MIK0141
2x handheld mic
clip mic
174-214 MHz, VHF
+/- 0.005%
FM
+/- 15 kHz
40 Hz – 20 kHz
>100 dB
>100 dB
<0,5%
Up to 50 meters
-10~50ºC
MIK0142
dual
1x handheld mic + 1
clip mic
EN
9
Werbung
Inhaltsverzeichnis
