Customer Service And Spare Parts; Installation / Positioning - Electrolux JRG94886 Gebrauchsanweisung

34 electrolux
GB

Customer service and spare parts

If you cannot find the remedy for a
malfunction in these operating instructions,
please contact your dealer or our customer
service department and consult the
Guarantee card.
Selective ordering of replacement parts
can save unnecessary travel and costs.
For this reason always provide the
following appliance information:
Model Name
Model Number (PNC)
Serial Number (S-No.)
This information can be found on the
rating plate inside the cabenit on the left
hand wall. We recommend that you enter
this information here, so that it is handy if
needed.
Technical specifications
The technical data is indicated in the
rating plate on the left side inside the
appliance.
If there is a power failure when
food is in the freezer, do not
open the door of the freezer
compartment.
The frozen food will not be affected if
the power cut is of short duration (up
to 12 hours) and the freezer
compartment is full, otherwise, it is
recommended that the food should
be used within a short time (a
temperature increase of the frozen
food shortens its safe storage
period).
Installation
Take utmost care when handling your
appliance so as not to cause any
damages to the cooling unit with
consequent possible fluid leakages.
During normal
condenser and compressor at the back
operation, the
of the appliance heat up considerably.
Always ensure that there is adequate
ventilation as a failure to do this will
result in component failure and possible
food loss. See installation instructions.
Important: if the supply cord is
damaged, it must be replaced by a
special cord or assembly available
from the manufacturer or its service
agent.
Positioning
Unpack the cabinet and check that it
is in good condition and free of any
transport damage.
The appliance must not be located
close to radiators or gas cookers.
Avoid prolonged exposure of the
appliance to direct sunlight.
For safety
ventilation must be as shown in Fig.
Attention: keep ventilation openings clear
of obstruction.
It is necessary that the niche is
provided with a conduct of ventilation
having the following dimensions:
Depth 50 mm
Width 540 mm
reasons, minimum