Installation - Crunch cr1000cap Bedienungsanleitung

INSTALLATION

For achieving the best results the capacitor should be located close-by the
amplifier. The cables between capacitor and amplifier should be short as possible
and should have large cross section. While installing the cables or the operation,
ensure not to damage the insulation of the cables.
1.) Tightly screw the device with the supplied brackets and screws as close as
possible to the amplifier on a machanically stable position. By no means install
the capacitor on any kind of speaker enclosure or on high vibrating positions.
2.) The correct wiring is displayed on the next page. To avoid any interferences,
connect the capacitor's ground connection at the same ground terminal like the
amplifier.
INITIAL CHARGING PROCESS
For the first initial charging use by any means the supplied resistor, to limit the
charge current and to avoid connecting sparks. Connect the "–" ground wire
with the "–" terminal of the capacitor. Then connect the remote-wire of the head
unit with the remote-terminal on the capacitor.
Then clamp the supplied resistor to the "+" terminal of the capacitor and hold
the "+" wire of the battery or distribution block at the other end of the resistor.
The resistor can be disconnected after approx. three minutes or if the capacitor
reached a load of 10 volts. Then connect the "+" terminal of the battery with the
"+" terminal of the capacitor to complete the charging process until 12~14 volts
are achieved.
During the charging process (between 5 ~ 10 Volt) a sound blip is hearable!
The resistor may get very hot during the charging process.
Please avoid any short circuit on the terminals.
"–" Ground
Terminal
Resistor
12
"+" Battery
Terminal