Operation - Pfeiffer uLam 1.2 Bedienungsanleitung

User Instructions uLam 1.2
The information below is important. To avoid
any problems please read this information
carefully before using the machine.
Always position the machine on a solid
work surface near an easily accessible
power socket.
Leave enough free space at the back of
the machine to allow the laminated
document to exit easily.
Do not laminate sharp or metal objects
such as staples and paperclips.
Do not laminate an empty pouch.
To avoid electric shocks, the laminator
must only be used indoors in dry condi-
tions, and water must not be allowed to
come into contact with the machine, the
electrical cord or the socket.
Do not use the machine if the electrical
cord is damaged.
Do not place next to sources of heat or in
direct sunlight.
For hot lamination - only use laminating
pouches designed specifically for hot
lamination.
For cold lamination - only use laminating
pouches designed specifically for cold
lamination.
Note: The laminating pouches included
with this laminator are intended for hot
lamination only.
The laminator is designed for occasional
small office and home use and is not
intended for commercial or industrial
applications.
After 2 hours of operation turn the ma-
chine off and allow to cool down for at
least 30 minutes.
Description
COLD / OFF / HOT switch
1
Power indicator lamp (Red)
2
Indicator lamp "Ready" (Green)
3
uLam_1.2_Laminator_content_EU.indd 5
Slot for pouch input (front)
4
Slot for pouch exit (rear)
5
Anti-Blocking Switch (ABS)
6
Trimmer
7

Operation

1. Setting up the machine
Turn the machine on by setting the switch
to the "HOT" position. The red "Power"
1
indication lamp will now glow.
2
The green "Ready" indicator
glow as soon as the laminator has
reached its operating temperature.
2. Lamination
Place the document to be laminated into
a laminating pouch of the appropriate
size. Make certain that all corners of the
document have at least two millimetres of
space to the edge of the laminating
pouch.
Slide the laminating pouch, sealed side
first, slowly into the pouch input slot
Guide the pouch into the laminator until it
is gripped and transported by the rollers.
The completed laminated pouch will exit
slowly from the pouch exit slot
rear of the machine. For best results re-
move the laminated item and place on a
flat surface to cool. Take care when
touching hot laminated pouches.
3. Release Function
If a pouch is pulled in at an angle or jams
inside the appliance, the following steps:
Push the Anti-Blocking Switch (ABS)
to the left, which prevents the laminating
pouch from being pulled further into the
machine.
Remove the laminating pouch from the
machine.
Restart the lamination process with a
new pouch.
EN
light will
3
.
4
at the
5
6
5
20.06.16 11:53