Before Use; Setting Up The Module - MinkPolice MP2 Gebrauchsanweisung

If you have several modules, the status reports are all collected into
one single message that is sent at your prescheduled time.

Before use

Read this user manual thoroughly before using your module. You
can also find guidance for setting up your module on
www.minkpolice.com. If you experience problems with the module,
read the section about troubleshooting at the end of this manual.

Setting up the module

2.1 Register the module online
Register as a user on www.minkpolice.com in the following three
steps:
- Click on Register and fill out the information.
- You will now receive an email with an activation link which you
must click on.
- Log into your profile on minkpolice.com and register your new
module (click on Register new device). The 5-digit module serial
number is located on the side of the module.
In the future when you log into your profile, you will see a list of
your modules along with their status and time of next expected
report from the module (wake up time). Read more about
configuration of modules in the online user interface below.
2.2 Insert Batteries and SIM Card into the module
- There must be a SIM card in each module. See
www.minkpolice.com for advice on choosing a SIM card. Remove
the pin lock from the SIM card or make sure that the SIM pin code
matches the last four digits of your module's serial number.
- Remove the lit from the box (screws must each be loosened a
little at a time).
MinkPolice User Manual
EN - 2