Step 4 - Install The Receiver - AEI DigiSender XDHDMI DGXDSDV112 Handbuch

DGXDSDV112 - DigiSender® XDHDMI - Single Input HDMI AV Sender System
Installing your DigiSender® XDHDMI

Step 4 - Install the Receiver

The Receiver will pick up the signals being sent by your Transmitter and output them to a connected
TV.
1.
Use one of the included HDMI cables and connect
it to the socket labelled 'HDMI OUT' on the back of
the DigiSender® Receiver and the HDMI input on
your receiving TV.
Please read the instructions carefully prior to installation
2.
Connect the Power Supply Unit (PSU) to the socket
labelled 'PSU' on the back of the DigiSender® Re-
ceiver and plug it into an available mains socket.
The Power Indicator will light up Red to indicate that
the unit is in Standby Mode.
ENGLISH (EN)
Page 07