Werbung
2
1. Connecting to water mains
- Connections to the mains water supply must be carried out by a qualified technician in compliance with
the manufacturer's instructions and applicable local safety regulations.
- All local Water Board regulations must be complied with. Water supply pressure: 0.03 - 1.0 MPa.
- The inlet hose must be securely clamped to the water tap to prevent leaks.
- The inlet water temperature varies according to the model installed. Inlet hose marked: "25°C Max":
up to a maximum of 25°C. Other models: up to a maximum of 60°C.
- Depending on the appliance model, the magnet valve of the inlet hose will be driven by the mains
voltage (see ** page 35).
- Make sure the inlet and drain hoses are kink-free and are not crushed.
- Fix the drain hose to the spigot with a clamp to prevent it from coming off during operation.
- On installation, make sure water can drain freely (take the spigot cladding off if necessary).
- Do not use old or damaged hoses. Use only the hoses provided or new ones, which can be requested
from the After-Sales Service.
- If hoses are not long enough, contact your local dealer.
- Do not cut hoses, and the plastic box containing the connection to the water mains in appliances with a
water cut-off system must not be under water.
- Before using the appliance for the first time, check water inlet and water drain for leaks.
2. Connecting to mains electricity
- All local Electricity Board regulations must be complied with.
- Voltage information is shown on the rating plate mounted inside the door on the right hand side.
- The appliance must be earthed as prescribed by law.
- Do not use extension leads or multi sockets.
- If necessary, the power cable may be replaced with an identical one that can be requested from our
After-Sales Service. The power cable must only be replaced by a qualified technician.
For Austria:
if the apparatus is series connected to a fault current switch, this must be sensitive to the pulsating
current.
3. Assembly instructions
- During assembly, unplug the appliance from the mains.
- Set any electrical screwdrivers to a low torque.
- Leave at least 3mm between the top edge of the wooden door and the worktop.
- Do not seal gaps between the appliance and adjacent units / worktop (for example with silicone).
- $WWHQWLRQ :KHQ WUDQVSRUWLQJ DQG DVVHPEOLQJ WKH DSSOLDQFH DOZD\V ZHDU JORYHV WR SURWHFW
WKH ILQJHUV KDQGV IURP VKDUS HGJHV DQG FRUQHUV
- If the appliance is installed at the end of a row of fitted units and touching a wall on one side, cover the
hinge area (available from the After-Sales Service).
- Be careful with uneven installation surfaces: regulate the foot height, push the dishwasher carefully
under the worktop.
- After fitting the decorative plates or plinth, before opening the door of the dishwasher, carefully check if the
plinth needs trimming and if so by how much (see page
- Protect the cutting edges of furniture units and baseboards from humidity (insulating material such as
silicone, not supplied).
4. General instructions
- The appliance must only be used in the household and according its purpose.
- Do not use the dishwasher until it has been fully assembled.
- Do not use the dishwasher if it has been damaged by transport. Contact the After-Sales Service or your
local dealer.
- Before cleaning or carrying out maintenance, switch off the appliance and turn off the water tap.
- All sizes in this maintenance and installation instruction are given in millimetres.
- Packaging varies according to the type of dishwasher
40
), in order to avoid damaging it.
.
4
Werbung
