Installation Instructions - Whirlpool CN 1150 AE Gebrauchsanleitung

GB
100% Made in ITALY Certificated
InstruCtIons For use and maIntenanCe
thank you for buying an Whirlpool product.
this sink proudly bears the Ce mark, as it has passed all the tests required by european Community
regulation unI en 13310:2004. every stage of our production process complies with the certified unI
en Iso 9001:2000 Quality system, and bears registration no. 1543-a, guaranteeing a high standard of
quality.
this product complies with regulation 1935/2004 and directive 89/109/Cee concerning materials
and articles intended to come into contact with foodstuffs.
Instructions for the installation, use and normal care of the sink are provided below.
these instructions will help you keep your sink in perfect working order for a long time.

InstaLLatIon InstruCtIons

Wear gloves when installing the sink
1. PaCKaGInG:
all packaging materials (plastic bags, polystyrene foam, etc.) are potentially dangerous and should be
kept away from children.
2. HoLes For tHe taP ConneCtIons
the sink comes to you with pre-prepared semi-bores of Ø 35 mm on both
sides. this lets you choose the side where you wish to install the tap.
after deciding which side you wish to use, the hole can be completed
using a dIamond Core installed on a manual drill, taking care to work
from the non-visible side.
3. BorInG tHe WorK surFaCe For InsertInG tHe sInK:
Place the sink upside-down on the work surface where it is to be installed.
trace around the outer edge of the sink using a pencil.
now move the sink and draw a dotted line 1 cm. inside the one you have just drawn using the sink as a
template. Cut along the dotted line using the appropriate tools.
4. FIttInG tHe sInK Into tHe WorK surFaCe
all our sinks come equipped with pre-installed mounting clamps. the following steps explain how to
install the sink correctly:
apply a special transparent sealant around the outer edge of the sink, wherever it will come into contact
with the work surface when the installation is complete.
make sure that all the clasps of the fastenings are facing inwards.
Insert the sink into the cut-out area of the work surface making sure it is centred.
tighten the fastenings using the adjusting screws, starting from the centre and working in a criss-cross
order.
5. InstaLLInG tHe draInaGe (draIns and draIn-traPs)
4