ISC PROFI V Montageanleitung Seite 4

Instructions for assembly, safety and use
GB
Dear Customer,
Thank you for choosing the PROFI V greenhouse.
We hope that you enjoy using your greenhouse.
This aluminum greenhouse is a product which has been
designed with the greatest of care. Not only does it
feature extremely sturdy profiles, but its compact and
modular design allows you to assemble it in next to no
time.
Before you set up the greenhouse, please take the time
to carefully read through these assembly instructions to
avoid damaging the equipment or setting it up incorrect-
ly. Once you have finished setting up the canopy roof,
please keep the instructions safe for future reference.
Web panels (plastic)
The web panels may be covered with protective foil on
both sides. The side with the printed foil is the outside
of the web panel (with UV coating).
Only remove the protective film from the plastic web
panel you are currently installing.
Please ensure that all packaging materials are recycled
through the appropriate channels.
Important assembly instructions
The greenhouse should be assembled on a single day.
The assembly work should not be undertaken in windy
conditions.
Note:
The manufacturer cannot be held liable for damage due
to storms, wind, water or snow loads. No guarantee is
offered in terms of compensation for consequential
damage or financial losses. We reserve the right to make
changes to the product as part of our process of
continuous technical improvement. This may result in
minor differences in the descriptions and/or illustrations. If
any component damage is evident then the affected
components should be replaced with genuine replace-
ment parts. The complete list of parts is set out in the
assembly instructions.
Important instructions for use
The greenhouse may only be used for the purpose for
which it is designed – growing plants in protected and
controlled conditions. It should not be used as a storage
facility or tool shed. The greenhouse cannot be used as a
conservatory. The manufacturer cannot accept any
damage caused by using the greenhouse for purposes
other than its designed purposes.
4
Important safety instructions for installation
• We recommend that the installation should be
performed by 2 persons.
• To prevent the risk of accidents, please keep children
at a safe distance during the installation work.
• Always wear protective gloves during installation of
the aluminum profiles. This will protect your hands
against the risk of being cut or trapped.
• Once you have finished assembling the greenhouse in
full, please retighten all nuts and bolts again.
Instructions for use
• All bolts, screws and nuts should be checked every
three months and retightened if required.
• After a storm or high winds please check all bolts,
screws and nuts and ensure that the plastic web panels
are correctly seated.
• In the event of a storm or heavy winds please close the
doors and windows of your greenhouse.
• Suitable storm anchorings (not included) should be
used to additionally secure the greenhouse in areas
particularly prone to storms.
• At temperatures below freezing (0 °C), never strike the
plastic web panels with hard objects.
• Snow should be cleared from the roof of the
greenhouse on a regular basis to prevent dangerous
snow loads from building up. A 10 cm layer of snow or
a 2 cm layer of ice can already be dangerous.
• The roof of your greenhouse is not designed to be
walked on.
• Never use any naked flames or similar in the
greenhouse. Only use approved heating equipment.
• Always make sure that you comply with the local
building regulations in your area.
!
Important:
When assembling the greenhouse, make sure that the
profiles are all perfectly square. Check the horizon-
tal and vertical positions of the profiles with a spirit
level.
Make sure that all profiles are assembled in their
defined end positions, pushed together as far as
they will go.